Return to README CVS log

Up to [local] / OpenXM / src / kan96xx / gmp-2.0.2-ssh-2 / mpn / sparc32

Annotation of OpenXM/src/kan96xx/gmp-2.0.2-ssh-2/mpn/sparc32/README, Revision 1.1

1.1     ! takayama    1: This directory contains mpn functions for various SPARC chips.  Code that
        !             2: runs only on version 8 SPARC implementations, is in the v8 subdirectory.
        !             3:
        !             4: RELEVANT OPTIMIZATION ISSUES
        !             5:
        !             6:   Load and Store timing
        !             7:
        !             8: On most early SPARC implementations, the ST instructions takes multiple
        !             9: cycles, while a STD takes just a single cycle more than an ST.  For the CPUs
        !            10: in SPARCstation I and II, the times are 3 and 4 cycles, respectively.
        !            11: Therefore, combining two ST instrucitons into a STD when possible is a
        !            12: significant optimiation.
        !            13:
        !            14: Later SPARC implementations have single cycle ST.
        !            15:
        !            16: For SuperSPARC, we can perform just one memory instruction per cycle, even
        !            17: if up to two integer instructions can be executed in its pipeline.  For
        !            18: programs that perform so many memory operations that there are not enough
        !            19: non-memory operations to issue in parallel with all memory operations, using
        !            20: LDD and STD when possible helps.
        !            21:
        !            22: STATUS
        !            23:
        !            24: 1. On a SuperSPARC, mpn_lshift and mpn_rshift run at 3 cycles/limb, or 2.5
        !            25:    cycles/limb asymptotically.  We could optimize speed for special counts
        !            26:    by using ADDXCC.
        !            27:
        !            28: 2. On a SuperSPARC, mpn_add_n and mpn_sub_n runs at 2.5 cycles/limb, or 2
        !            29:    cycles/limb asymptotically.
        !            30:
        !            31: 3. mpn_mul_1 runs at what is believed to be optimal speed.
        !            32:
        !            33: 4. On SuperSPARC, mpn_addmul_1 and mpn_submul_1 could both be improved by a
        !            34:    cycle by avoiding one of the add instrucitons.  See a29k/addmul_1.
        !            35:
        !            36: The speed of the code for other SPARC implementations is uncertain.