METAFONT Terminal Driver for gnuplot (mf.trm):
----------------------------------------------
The METAFONT terminal driver creates a input file to the METAFONT program.
Thus a figure may be used in the TeX document in the same way as a
character is.
To use the plot in a document the METAFONT program must be run
with the output file from gnuplot as input. Thus, the user needs a basic
knowledge of the font creating prosess and inclusion of a new font in a
document. However, if the METAFONT program are set up properly at the
local site an unexperienced user could perform the operation without
much trouble.
The text support is based on a METAFONT character set.
Currently the Computer Modern Roman font set is input but the
user are in principal free to chose whatever fonts he/she needs.
The METAFONT source files for the chosen font must be available.
Each character is stored in a separate picture variable in METAFONT. These
variables may be manipulated (rotated, scaled etc.) when characters are
needed. The drawback is the interpretation time in the METAFONT
program. On some machines (i.e. PC) the limited amount of memory available
may also cause problem if too many pictures are stored.
To use the METAFONT terminal driver:
------------------------------------
1) In gnuplot use: set terminal mf
set output "myfile.mf"
.
.
.
plot ....
exit
2) Run METAFONT. Syntax is site dependant:
On my UNIX I use: cmmf '\mode=localfont; \mag=1;' input myfile.mf
On my PC I use: mf286 &cm \mode=localfont; \mag=1; input myfile.mf
Be aware that METAFONT can only handle number less than 4096. Thus if you
have very high resolution in your localfont and a large picture you will
probably get an error message when running METAFONT. To solve the
problem,
reduce the resolution or the plot size.
3) Run GfToPk, syntax is
on my UNIX: gftpk myfile.xxxgf myfile.pk
on my PC: gftpk myfile.xxx myfile.pk
where xxx is the resolution (typically 300).
4) Copy the files myfile.pk and myfile.tfm to a place where you are sure TeX
and the dvi processing programs you use can find them. (They can
probably
be located in your current working directory)
5) Include in your TeX document the following statement:
\font\myfont=myfile % Declares the new font you just have made
{\myfont\char0} % Typeset character with code zero which
% MF.TRM uses as default character
Paal Hedne
SINTEF Multiphase Laboratory
N-7034 Trondheim
Norway
Tel.: -47-7-591060
E.mail: Pal.Hedne@termo.unit.no